3M 2282L - ELECTRODE, ECG, NEO, RADIOLUCENT, 0.9", CLOTH, 300 EA/CS

3M 2282L - ELECTRODE, ECG, NEO, RADIOLUCENT, 0.9", CLOTH, 300 EA/CS

3M 2282L Red Dot ECG Monitoring Electrodes

Neonatal, Pre Wired, Radiolucent Monitoring Electrode with clear tape. Because of the importance of monitoring newborns and infants, a family of pre-wired electrodes were specifically designed with them in mind.

Features and Benefits of 3M 2282L Red Dot ECG Monitoring Electrodes

• This neonatal, radiolucent, monitoring electrode features pre-attached lead wires and clear tape backing
• Clear tape backing allows for easy viewing of patients skin condition
• Conductive adhesive provides excellent trace quality for reliable results
• Clinically tested for up to 3 days wear
• Radiolucent and MR Conditional
• Can be used to monitor neonates or infants

3M 2282L Red Dot ECG Monitoring Electrodes Application Instructions

Prepare the skin.

• Application sites must be clean, dry and free of any body lotions. Cleaning with isopropyl alcohol should be avoided or limited to situations in which electrode adhesion is an issue (excessively oily or lotion covered skin). If alcohol is used, allow it to dry prior to electrode application.
• Excessive hair at the site should be removed by clipping.

Apply the electrodes.

• Remove the electrodes from the sealed package. Separate and straighten the leadwires.
• Remove the first electrode from the liner.
• Place the electrode on the patient and use gentle pressure to ensure contact of the entire electrode surface to the skin.
• Repeat for each electrode.

Connect the leadwires to the cable yoke.

• Remove a DIN plug from the disposable holder and plug it into the corresponding color on the cable yoke.
• Repeat for each DIN plug.

Removal Instructions of 3M 2282L Red Dot ECG Monitoring Electrodes

• Loosen one side of the electrode. Grasping the full width of the electrode, slowly and gently pull it back over itself.
• Electrodes should be removed in the direction of hair growth whenever possible. Keep the electrode close to the skin surface as you pull it back, and support the skin immediately adjacent to the adhesive being removed.
• To remove the DIN plug from the cable yoke, grasp the plug firmly and pull. Repeat for each DIN plug.

DO NOT remove the DIN plugs from the cable by pulling on the wires.

3M 2282L Red Dot ECG Monitoring Electrodes Specifications

3M 2282L Red Dot ECG Monitoring Electrodes Dimensions and Classifications